Your vga driver needs updating

no: ACPI Operation Regions are not marked as reserved, no further checks are performed.

PARIDE The Par IDE (parallel port IDE) subsystem is enabled. lax: access to resources claimed by ACPI is allowed; legacy drivers trying to access reserved resources will bind successfully but a warning message is logged.

Some of these parameters may be changed at runtime by the command "echo -n $ /sys/module/$/parameters/$". bttv.card= [HW, V4L] bttv (bt848 bt878 based grabber cards) bttv.radio= Most important insmod options are available as kernel args too.

The parameters listed below are only valid if certain kernel build options were enabled and if respective hardware is present. bttv.pll= See Documentation/video4linux/bttv/Insmod-options bttv.tuner= bulk_remove=off [PPC] This parameter disables the use of the p Series firmware feature for flushing multiple hpte entries at a time.

s4_nohwsig prevents ACPI hardware signature from being used during resume from hibernation.

s3_beep is for debugging; it makes the PC's speaker beep as soon as the kernel's real-mode entry point is called.

These options have more detailed description inside of Documentation/m68k/ 32: only for 32-bit processes 64: only for 64-bit processes on: enable for both 32- and 64-bit processes off: disable for both 32- and 64-bit processes alloc_snapshot [FTRACE] Allocate the ftrace snapshot buffer on boot up when the main buffer is allocated.

DRM Direct Rendering Management support is enabled. The parameter defines the maximal number of local apics being dumped.

align_va_addr= [X86-64] Align virtual addresses by clearing slice [] when allocating a VMA at process creation time.

MTD MTD (Memory Technology Device) support is enabled. Bit 0 enables warnings, bit 1 enables fixups, and bit 2 sends a segfault.

amd_iommu= [HW, X86-64] Pass parameters to the AMD IOMMU driver in the system.

LIBATA Libata driver is enabled LP Printer support is enabled. This is handy if debugging and you need to use tracing_snapshot() on boot up, and do not want to use tracing_snapshot_alloc() as it needs to be done where GFP_KERNEL allocations are allowed.

Search for your vga driver needs updating:

your vga driver needs updating-72

Leave a Reply

Your email address will not be published. Required fields are marked *

One thought on “your vga driver needs updating”